3000MW BLUE CNC DIY Laser Engraving Cutting Machine (Large 28" x 25") 65cm x 50c

Description

3000MW BLUE CNC DIY Laser Engraving Cutting Machine (Large 28" x 25") 65cm x 50c.   I bought this new a few months ago and paid 0 for this at Engraver World, and only used it a couple of times.  I am not very techy and cannot figure out the settings and software.  You have to install a driver and use Benbox software. The 1 small logo that I engraved on wood looked really good, but it took me forever to get it.  I dont have enough patience to figure it out and the instructions were not very helpful.    If you can figure it out, my loss is your gain.  Specs are below:
Can engrave on:
Wood
Bamboo
Plastic
Paper
Leather
Cards
Rubber
Good for Cutting:
Paper
Thin Leather
Foam
Not Suitable for:
Metal
Stone
Ceramic
shell
Light-reflecting or transparent material
4. Tech Specs:
Material:stainless steel and acrylic
Working Voltage:DC 12V
Laser Power: 3000mW
Drive system: stepper motor (step accuracy: 0.1mm)
Engraving speed: 200-2000m/min
Cutting speed: 1-100ms/pixels
Operating temperature: -10 - 45 degrees
Engraving Area: 65x50cm(maximum)
Size: 72x63cm
Cooling mode: air cooling
Whole machine weight: About 5kg
Machine net weight: About 4kg
Control software: benbox software support power can be adjusted, weak light positioning
I will have to take it apart to ship it.  I can leave most of it together, however I will have to take off the top and disassemble the 4 sides.