Air Assist Upgrade For Laser Master 2 Laser Engraver

Description

Ortur Laser Master 2 - Air Assist - Air Pump Tubing not included in this listing (Please see below)
Smoke coming from your engraved surface can get on your laser's lens. A dirty lens equals poor engraving. So, make sure to keep your lens clean for clean, even burns. Our air assist rids the desired surface of debris and also keeps smoke off your laser's lens. Get deeper cuts by removing the debris with air assist, cleaner engravings and overall better performance. If you have shop air that is recommend between 20-25psi. Small pumps will show great improvement as well but not as good as the larger pumps.
Install:
-Attach Articulated hose to square frame
-Install the M3 screw and nut into the square frame
-Replace spacer on you laser module with the supplied hose attachment spacer (see photos in listing)
-Attach Frame to the module
-Install your 6mm hose (not supplied) see below link for bundle
-Secure hose with zip ties to the wire loom
-Place Nozzle at 45 Degrees 2-3mm from laser dot on workpiece.
Construction:
Frame ( laser dimension 40 x 40 mm ) for attaching to the laser + screw + nut
Hose attachment spacer
Articulated links
**Medical tubing not included in this listing, Please visit link to air assist + 6ft of tubing (https://www.ebay.com/itm/333895722447) if you need the air pump hosing included.
If you need air tubing + the air assist visit here -
https://www.ebay.com/itm/333895722447
King Gubby Designs has been solving problems for lasers printers for a few years now. When we encounter a consistent problem or design flaw with a machine we use, we get to work coming up with a solution. This product is one of those solutions.
We hope you enjoy it.
- The laser and hose shown is for illustrative purposes only and is not part of the offer.
---
Approved License and usage
©Tobias Vollmer