Altronix AL802ULADA NAC Power Supply 2 Class-A or 4 Class-B Outputs 8 AH 8 AMP

Description

Brand New.  Just in stock.  We will only accept the same exact unit back for replacement if defective.
Altronix AL802ULADA is an extremely
cost-effective
voltage regulated remote NAC Power Extender. It may be connected to any 24-volt Fire Alarm Control Panel (FACP). Primary applications include Notification Appliance Circuit (NAC) expansion (supports ADA requirements) and providing auxiliary power to support system accessories.
Input
§
Voltage:
o
120VAC, 60Hz, 4A.
o
Two (2) Class A or two (2) Class B inputs.
o
Two (2) NC dry contact trigger inputs.
§
Input Ratings (INP1 and INP2):
o
8-30VDC 6.5mA max from FACP.
o
12V 6.5mA, 24V 6.5mA from FACP.
Output
§
Voltage:
o
24VDC power-limited outputs.
§
Current:
o
8A max. total alarm current.
o
2.5A max. current per output.
§
Auxiliary:
o
1A.
§
Other:
o
Thermal and short circuit protection with auto reset.
o
Filtered and regulated outputs.
§
Programmable Supervised Indicating Circuit Outputs:
o
Four (4) Class B, or TWO (2) Class A, or
o
One (1) Class A and Two (2) Class B.
Back-up Battery (not included)
o
Type: Sealed lead acid or gel type.
o
Failover: Upon AC loss, instantaneous.
Supervision
o
AC Failure: Form “C” contacts.
o
Battery: Form “C” contacts.
Indicators (LED)
o
AC Power (Green): Input voltage is present.
o
DC Output (Red): Powered.
o
Logic Board (Red and Green): Output status.
Special Features
o
2-wire horn/strobe Sync mode allows audible notification appliances (horns) and visual notification appliances (strobes) to be silenced/deactivated at the same time.
o
Sync protocols include Potter/Amseco, Gentex®, System Sensor®, and CooperWheelock®.
o
Temporal Code 3, Steady Mode, Input to Output Follower Mode (maintains synchronization of notification appliances circuit).
o
Compatible with 12VDC or 24VDC fire panels.
o
Output loop supervision steered to Input 1 or Input 2.
o
Signal circuit trouble memory (helps identify intermittent loop problems).
o
Common trouble input and output for external trouble signals tie-in.
o
Ground fault detection.
Temperature
o
Operating: 0° C to 49° C (32° F to 120° F).
o
Storage: - 20° C to 70°C ( - 4° F to 158° F).
o
Relative Humidity 85% +/- 5%.
o
BTU/Hr (approx.): 31 BTU/Hr.