Carbon Fiber Handmade Coating process DIY Kit suitable for initial enthusiasts

Description

Package includes：
1，Abrasive paper : 8 slice ( 240Cw*2slice,
600Cw*2slice, 100
0Cw*2slice,
2000Cw*2slice)
2,  Grinding paste :  1 pcs
3,  gauze mask:  2 pcs
4,  Stirring rod : 6 pcs
5,  paper adhesive tape ：1 roll ( 12mm width*45m)
6,  gloves： 2pair
7,  Measuring cup 30ml: 4pcs
8,  Brush: 6pcs (2# 1.5cm*13.5,  3# 2.2*13.5, 8# 4.5*15.5)
9, primer glue:  A:B=1:1(A: epoxy resin 150g, B : hardener 150g)
10, Surface glue : A:B=3:1 (A: epoxy resin 330g.B:
hardener
110g)
11, Carbon fiber cloth default
plain weave:  20cmx100cm 1slice.
12, If you need change to twill fabric, please drop me a message.
Use the tutorial
1，Use the tutorial text description. 1. Remove the items that need to be DIYed from the equipment, then use 400-grit sandpaper to roughen the surface on the surface to be pasted, and then clean it up. Use masking paper where you don't need to do it to avoid sticking to the glue。
2，Cut the carbon fiber cloth, put the object on the cloth, and cut the edge beyond the object by about 5 cm. When cutting, pay attention to paste the textured paper to prevent the carbon cloth from loosening (cut in the middle of the textured paper).
3，The function of the primer is to combine the components of the item with the carbon fiber without leaking. The colloid will not cure for a long time), after the glue is configured, let the glue stand for 5-10 minutes (to let the bubbles disappear), when painting, it should be a little thinner (0.5mm), and the edge position can be slightly more, This facilitates closing.
4，When the glue has not cured temporarily and is sticky (about half an hour later), start to apply the cloth, gently place the cut cloth on the object that has been brushed with glue, adjust the whole position, use the palm of your hand to lightly Lightly compact, be careful not to use other methods (it is easy to deform), after the carbon cloth is compacted, stick the masking paper to the edge of the object and stick it to the back of the object to prevent the edge from warping, and then use household plastic wrap to cover the entire object. Wrap it up and wait for about 2h to initially cure the primer.
5，Because the operation process is very long, the store cannot be fully described. After you purchase the order, if you encounter problems, please contact us.