Exhaust With Muffler for: Coleman CT200U 196cc/6.5HP Gas mini bike.

Description

You must know this before you make your purchase!
-
There is no painting in this exhaust,
Rust can come out over time,
"solution" you
applies high heat paint.
-
This muffler is a little more Loud than the factory.
-
you must use a pliers to tighten it!
-
This exhaust will change color due to the high heat generated by the engine.
Type of material:
Mild steel,
Uncoated Steel.
-
Right
side Exhaust.
- Muffler for
4-8HP only.
governor removed
? this muffler can not take it, it will break into two pieces!
-
3/4
Stainless steel
female thread.
- 2 Lock washer and 2 nut included.
- Heavy duty pipe.
- Heavy duty 1/4 Exhaust Flange.
- Gasket.
>>>Mini Bike not included<<<
This been tested
on
Coleman  CT200U 196cc/6.5HP Mini bike.
Exhaust pipe Made
in U.S.A.
We only ship to paypal confirmed address.
Florida residents
pay 7
%
taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry standard for the sizes of pipe is not always as straight-forward as measuring the pipe.
Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is measured and based on the inside of the pipe. But, to actually determine the size of a pipe, the outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per inch) and OD (outside diameter) of the thread are required for positive identification of thread size because several sizes have the same TPI.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Please check
my other
Header (on other audition)